SCAN DSA 4 Bedienungsanleitung

Page 1 INSTRUCTIONS FOR INSTALLATION AND USE SCAN DSA 4 Tested &Listed byBeavertonO regon U SAOMNI-Test Laboratories, In

Page 10 Note: Most factory built chimney manufactures make stainless steel chimney liners, either flexible or rigid. This provides a wide variety o

Page 11 4.7 Surround Panel Installation (see part numbers below) Surround panel size is determined by the type of installation and the size of the

Page 12 4.9 Draft Requirements: The SCAN DSA fireplace is only one component of the total system. The venting system is equally important for achie

Page 13 5. OPERATION WARNING: DO NOT USE GASOLINE, LIGHTER FLUID, KEROSENE OR OTHER FLAMMABLE LIQUIDS TO START OR FRESHEN A FIRE IN THIS INSERT. KE

Page 14 5.3 Refueling: To refuel the fireplace, first move the air intake control to full open, let the fire “liven-up” for about one minute. Open

Page 15 6. MAINTENANCE 6.1 Ash Disposal and Removal: CAUTION: Be sure the fire is out and stove is cold before removing ashes! Be careful when

Page 16 6.4 Creosote Formation and the Need for Removal: When wood is burned slowly, it produces tar and other organic vapors, which combine with e

Page 17 6.6 Replacement part list: Caution: Use only original SCAN DSA 4 replacement parts. Do not use substitute materials. Replacement part P

Page 18 7. WARRANTY PROVISIONS FOR SCAN WOOD BURNING PRODUCTS All scan wood stoves; inserts and fireplaces are subject to a strict quality control

Page 19 8. TROUBLESHOOTING Smoke: - Insufficient chimney draught! - Check chimney height. Recommended height is minimum 15 feet. - Check

Page 2 CONTENTS 1. IMPORTANT SAFETY NOTICE ...

Page 3 Congratulations on your new SCAN DSA wood burning fireplace. We are confident that you will enjoy your new SCAN DSA fireplace, especially if

Page 4 2. CAUTIONS IF THIS FIREPLACE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESLUT. FOR YOUR SAFETY FOLLOW THESE INSTALLATION INSTRUCTIONS. C

Page 5 3. INTRODUCTION / INSTRUCTIONS FOR USE 3.1 About the SCAN DSA 4 fireplace SCAN DSA 4: CAUTION: Do not operate the fireplace with the sta

Page 6 3.5 Room Ventilation: During the combustion, oxygen taken from the room air is used. In rare cases it may be necessary to mount a fresh-air

Page 7 4. INSTALLATION (Qualified technicians only) WARNING: Check all local building and safety codes before the installation. The installation

Page 8 4.3 Hearth and floor protection requirements: The floor in front of the fireplace needs thermal protection of ¾ inch (19 mm) thick mineral f

Page 9 4.4 Masonry Fireplace Requirements • Chimney must have a clay tile liner or a stainless steel liner (positive connection). • Entire firepl